国产在线观看高超|久久精品亚洲国产AV|日韩第三页欧美aa在线|2018国产大陆天天弄a|欧美精品性爱一区二区三区|办公丝袜av一区二区三区|国产精品久久久久久亚洲视频|国产精品毛片av—区二区三区

[intelligent manufacturing] how to make the average speed of the tile line to reach 200 m / min?

DATE：2016-09-23   Page view:2083

1, set the goal of tile line equipment: normal speed of about 90% Such as tile line design speed of 250 m / min, the normal target production and speed should be: 220 five m / min, 230 layer three m / min. 2. Find the corresponding process parameters of temperature and glue physical index to match the target production speed. Such as the temperature range of each piece of paper and the corresponding temperature, viscosity and solid content of the glue. At present, most of the factory's temperature control is based on the operator's experience of manual control. The ability of the operator and the responsibility of the heart is very high. The temperature control of the wet part of the tile line is recommended ". 3, optimize the order structure, improve the scheduling of single program to reduce the impact on the efficiency of production. 4, to participate in the production of staff management assessment, to mobilize the enthusiasm of the staff involved in management Note: the management responsibility to the people (loss, quality, efficiency, 6S), do not eat rice pot. 5, all the factors affecting the efficiency of records, analysis, find reasons, research solutions Such as: 1) stop, broken paper, paper, paper jam, fault reason, and so on, roll change time; 2) have poor quality such as quality problems of Gao Kezhong base drive fast speed or high speed; 3) wet for a single short length, the paper is not urgent, such as the length of less than 500m; 4) cadres for a single length short, continuous small orders, small orders, cadres cut long for a single slow; 5) logistics system can not keep up the speed; 6) operator and coordination ability. 6, repeat the process, the formation of a virtuous cycle.

【Back】